Recenzje klientów dla Imadło do frezowania 3" z blokadą obrotową i zaciskiem stołowym o wysokiej precyzji

A lot of vice for the price and a good heavy casting, well ground surface finish on the sliding surfaces and jaws. I just had to tidy up the edges of the base with a file as they were still sharp from grinding. The base will eventually be scraped in but for now it’s good enough. I think the maximum deviation over all with the vice fully open from fixed jaw to moving was with in 0.06mm I have provided photos showing DTI deviation but can only post five

Good value good quality. You need to adjust the Jaws to true parallel. Easy to do slacken Allen bolts and set to parallel with milling table

Good quality, easy to use. Fixing bolts were too big for my mini mill but I had some already I could use.

Got this after struggle with a smaller vise. These are modelled after the famous design of the American Kurt vise, but at a tiny fraction of the price. So wasn't expecting it to be as good as it turned out to be. Was well packed, came with a fixing kit, and was no trouble to setup. After fly cutting a part both sides on parallels the thickness was almost same on all corners (just over 0.01mm). Extremely good clamping force.

Very Pleased, just right for my mini mill **************************************************************************************************************************

Arrived very quickly, well packed. Very strongly built considering low price. Used for a week of continuous milling and never slipped once. Overkill for my Chester 626 mill I hadn't realised how big it was! Delighted with it except for the handle which was a little oversize and was marking the hexagon shaft. However the remedy was to substitute handle for a spanner. It still rates 11 out of 10 for me.

I just use this on my drill press and for the price it works for me .

Little larger than I thought it would be but it does the job.Amendment 04/04/21 I had a little incident and there was some damage done to one of the vise jaws. After going back and forth with the vendor for a number of days they told me they cannot supply replacements. They then told me to talk to Amazon customer service. Amazon Customer Service helped to straighten out everything to my satisfaction. Amazon, not the vendor, was simply amazing in this case.

This vice is very accurate, with no lift on the moving jaw. Really good for the money. I'm happy

ok so it's not the best available but that said you have to consider what you get for your money and that is a perfectly adequate tool for the home workshop. Needed a good clean before use and the odd bit of deburring but hey look at the price