Recenzje klientów dla VEVOR Zbiornik ciśnieniowy Zbiornik na farbę Zbiornik ciśnieniowy na farbę w sprayu Zbiornik ciśnieniowy 2 l Pistolet natryskowy 45 psi Zbiornik na farbę Φ38,5 x 12,6c Zbiornik ciśnieniowy na farbę w sprayu Pojemnik na farbę Pistolety do malowania w sprayu Farby, bejce

Good bit of kit, sturdy & seems to be well made. I've converted it into a pressure pot for resin casting, holds the pressure after capping off the outlet & fitting a tap to the inlet.

Great quality pressure pot made sturdy, easy to use handy with the lift out stainless Steel pot ,long may it last

i bought this for £70 on the vevor site with free delivery (even got £5 off because it was my first order from them) and even though i havent used it yet it seems like its pretty much set up to be used for resin (i think) as all you need to do is buy a cap for the elbow to stop the air escaping

The conversion was painless and it has worked flawlessly since I bought it. I recommend this product.

I bought this paint pot to paint my garage. It was easy to use and it made the job easy and fun. It was easy to adjust and I recommend this for painting jobs. I used latex paint for this project.

Very strong and well made

Customised it for resin casting, works great

so I need to start this review by stating I'm not using the pressure pot for what it was designed for , I have converted it for resin casting . It would have been 5 stars apart from some of the fittings , mainly the regulator and gauge .The pot is relatively cheap with most of them _50 to _100+ more so I have taken that into account , pot is a well made thick gauge metal with a silicon seal in the lid , the air inlet has a side diverter meaning its not going to blow the resin etc out of the mould when you charge it . everything fitted to it is fine until you get to the pressure gauge and associated fittings , the body is plastic and already out of shape from shipping , feels like its going to fall apart just from handling however the biggest issue is its rated in MPA not PSI or BAR , which is easy to convert with google but an added complication and it goes way over what the vessel is rated for which could lead to some very nasty accidents if you don't get it right .The pressure vessel is easy to convert with a couple of extra fittings and PTFE plumbers tape but I would strongly recommend replacing the regulator with a decent PSI rated one before use .I did put 40 psi into the unit 24 hours ago and it has held the pressure . The inside is a decent size for most of the turning and casting work I would ever need to put in it .in summary - buy a decent gauge and its a very handy tool

i converted it to make a pressure pot and i am very pleased with it

The gauge leaks, therefore cannot hold pressure until replaced.As long as you do a small amount of research or know what you're doing this can very very easily be turned into a pressure pot for resin casting. I use it as 50-55 psi and just had to plug one side and buy a new gauge ($8) not a big deal but just a heads up. That being said, I also used thread seal just to be sure there is no leaks. Teaming it with a small compressor, I had a functioning pressure pot w/compressor for ~$220 which is great in my opinion.In short, worth the small amount of work it took to convert it. And it is holding pressure and functioning great.