Recenzje klientów dla Zestaw narzędzi do drążków kierowniczych VEVOR Demontaż drążków kierowniczych 13 sztuk 1/2" Akcesoria samochodowe

This tool is not fit for purpose. The poor fit of the crows feet in the tube and weak construction of the crows feet mean that their jaws spread and slip before the tie rod end lossens.

I recently had to replace a tie rod on a Ford Escape. While I probably could have done it without this tool, it certainly made the process much easier.

Exelente la entrega

It have a lot of fittings for different size tie rods. My toyota yaris used the two smallest fitting. There is two indentation on the tie rods that the fitting goes into. You slide the tie rods into the metal tubes and line the cut out at the end on the tube with the fitting. You secure the fitting in place by twisting the ring on the tube. You then pull the fitting toward yourself so the fitting grabbed onto the indent of the tie rods. Then, You use a 1/2 ratchet or breaker bar and remove the tie rods. There's no other device that I found that would remove the tie rod because tie rods is round and have grease on them, making it difficult for tools to grab onto the tie rods. This device made replacing tie rods very easy. The only cons is it is hard to twist the ring to secure the fitting in place. This products would have been a five star if it was made with the ring on the tube easier to grab and rotate.

it worked for what i needed it for but the tube is a bit small , did not fit the knuckle on a 98 lumina , factory inner tie rod, will not fit in to be able to lock the ring but still got the job done so gets a 4 star rating

Muy buen producto para facilitar tu trabajo